Filter
Top Products
Connecting your equipment03
20
En
Bare wire connections
A-Speaker terminals:
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
B-Speaker terminals:
1 Twist exposed wire strands together.
2 Push open the tabs and insert exposed
wire.
3 Release the tabs.
CAUTION
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Make sure that all the bare speaker wire is
twisted together and inserted fully into the
speaker terminal. If any of the bare speaker
wire touches the back panel it may cause
the power to cut off as a safety measure.
Switching the speaker terminal
If you selected Surr.Back in The Speaker
System setting on page 49, you can switch
between speakers using the SPEAKERS
button. If you selected Height, the button will
simply switch your main speaker terminal on or
off. The options below are for the Surr.Back
setting only.
1
• Use the SPEAKERS button on the front
panel to select a speaker terminal setting.
2
Press repeatedly to choose a speaker terminal
option:
• SPA – Sound is output from the speakers
connected to the A-speaker terminals
(multichannel playback is possible).
• SPB – Sound is output from the two
speakers connected to the B-speaker
terminals (only stereo playback is
possible).
• SPAB – Sound is output from the A-
speaker terminals, the two speakers in the
B-speaker terminals, and the subwoofer.
Multichannel sources are downmixed only
when the STEREO or ALC mode is selected
for stereo output from A- and B-speaker
terminals.
• SP – No sound is output from the
speakers.
123
10 mm
(
3
/8 in.)
12 3
10 mm
(
3
/8 in.)
Note
1 All speaker terminals (except Speaker B connections) are switched off when headphones are connected.
2 The subwoofer output depends on the settings you made in Speaker Setting on page 45. However, if SPB is selected above,
no sound is heard from the subwoofer (the LFE channel is not downmixed).
SPEAKERS DIMMER DISPLAY
VSX-920_UCSMXCN_En.book 20 ページ ２０１０年１月２１日 木曜日 午前９時４３分