Filter
Top Products
Other Settings12
66
En
Chapter 12:
Other Settings
The Input Assign menu
You only need to make settings in the Input
Assign menu if you didn’t hook up your digital
equipment according to the default settings for
the digital inputs, or if you have connected
equipment using component video cables.
1 Select ‘IN ASSIG.’ from the System Setup
menu.
See
Making receiver settings from the System
Setup menu
on page 43 for more on this.
2 Use
/
(cursor left/right) to select the
setting you want to adjust then press
ENTER
.
•
DIG. IN
– See
Assigning the digital inputs
below.
•
COMP. IN
– See
Assigning the component
video inputs
below.
Assigning the digital inputs
• Default settings:
COAX 1
(coaxial) –
DVD
COAX 2
(coaxial) –
CD
OPT 1
(optical) –
TV
OPT 2
(optical) –
DVR
You only need to do this if you didn’t hook up
your digital equipment according to the default
settings for the digital inputs (see above). This
setting tells the receiver what digital
equipment is hooked up to which terminal so
the buttons on the remote correspond to what
you have hooked up.
1 Select ‘DIG. IN’ from the ‘IN ASSIG.’ menu.
2 Select the number of the digital input to
which you’ve connected your digital
component.
Use the
/
(cursor left/right)
buttons to do
this.
• The numbers correspond with the
numbers beside the inputs on the back of
the receiver.
3 Select the component that corresponds
with the one you connected to that input.
Use the
/
(cursor up/down)
buttons to
select
DVD
,
TV
,
CD
,
CDR
,
DVR
or
OFF
.
• If you assign a digital input to a certain
function (for example,
DVD
) then any
digital inputs previously assigned to that
function will automatically be switched off.
4 When you're finished, press RETURN.
Assigning the component video inputs
• Default settings:
COMP 1
–
DVD
COMP 2
–
TV
COMP 3
–
DVR
When you select an input source (
DVD/LD
,
TV/SAT
, etc.), the receiver outputs the
component video signal assigned to that
source. If you didn’t make component video
connections according to the defaults above,
you must assign the numbered input to the
component you’ve connected (or else you may
see the video signal of a different component).
For more on this, see
Using the component
video jacks
on page 21.
1 Select COMP. IN from the IN ASSIG. menu.
VSX_815-915.book.fm 66 ページ ２００４年１２月８日 水曜日 午後４時３分