Filter
Top Products
Connecting up
04
25
En
English
Français
Deutsch
Nederlands
Italiano
Español
• Make sure no exposed speaker wire is
touching the rear panel, this may cause the
receiver to turn off automatically.
Overhead view of speaker setup
You can also refer to the 3-D speaker setup
illustration on page 10.
.
The diagrams below show suggested surround
and surround back speaker orientation. The
first diagram (
fig. A
) shows orientation with one
surround back speaker (or none) connected.
The second (
fig. B
) shows orientation with two
surround back speakers connected.
3-D view of
7.1 channel
speaker setup
AC outlet
Power supplied through this outlet is turned on
and off by the receiver's power switch. Total
electrical power consumption of connected
equipment should not exceed 100 W (0.8 A).
• This unit should be disconnected by
removing the power plug from the wall
socket when not in regular use (ex. when
on vacation).
Caution
•
Do not connect a TV set
, monitor, heater, or
similar appliance to this unit's AC outlet.
• Do not connect appliances with high
power consumption to the AC outlet in
order to avoid overheating and fire risk.
This can also cause the receiver to
malfunction.
• Since a subwoofer or power amplifier can
exceed the 100W maximum when playing
sources at a high volume, this type of
equipment should not be connected to the
AC outlet.
Surround
left
Surround
right
Listening position
Front
left
Front
rightCenter
Subwoofer
Surround back Surround back
Single surround back speaker
left right
90~120
fig. A
fig. B
LS
LS
RS
RS
SB
LS
RS
0~60
SBL
SBL
SBR
SBR
AC OUTLET
VSX_815-915.book.fm 25 ページ ２００４年１２月８日 水曜日 午後４時３分