Filter
Top Products
Listening to your system06
42
En
Playing other sources
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to playback.
Use the
MULTI CONTROL
buttons (or
INPUT
SELECT
).
1
4 Start playback of the component you
selected in step 1.
Selecting the multichannel
analog inputs
If you have connected a decoder or a DVD
player with multichannel analog outputs to this
receiver (page 18), you can select them for
surround sound playback.
2
1 Make sure you have set the playback
source to the proper output setting.
For example, you might need to set your DVD
player to output multichannel analog audio.
2 Press DVD/LD.
3 Press
SIGNAL SELECT
to select the
multichannel analog inputs.
DVD 5.1ch
will show in the display and the
ANALOG
SIGNAL SELECT
indicator will light.
Using the sleep timer
The sleep timer switches the receiver into
standby after a specified amount of time so you
can fall asleep without worrying about the
receiver being left on all night. Use the remote
control to set the sleep timer.
• Press
SLEEP
repeatedly to set the sleep
time.
• You can check the remaining sleep time at
any time by pressing
SLEEP
once. Pressing
repeatedly will cycle through the sleep
options again.
3
Note
1 If your source is the TV’s built-in tuner, switch to the channel you want to watch, otherwise make sure that the TV’s video input
is set to this receiver (For example, if you connected this receiver to the
VIDEO 1
jacks on your TV, make sure that the
VIDEO 1
input is selected). Turn down the volume of your TV so that all the sound is coming from the speakers connected to this receiver.
2• When playback from the multichannel inputs is selected, you can’t use
ACOUSTIC CAL EQ
,
DIALOG E
,
INPUT ATT
,
TONE
,
VSB
and
MIDNIGHT/LOUDNESS
, as well as any of the listening modes (including
STEREO/DIRECT
and the Extended mode).
• When playback from the multichannel inputs is selected, only the volume and channel levels can be set.
• You can’t listen to your speaker B (Second Zone) system during playback from the multichannel inputs.
RECEIVER
MULTI CONTROL
SOURCE
INPUT
SELECT
DVD/LD TV/SAT DVR/VCR TV CONT
CD
CD-R/TAPE
TUNER RECEIVER
STANDARD
ADVANCED
SURR
ST/DIRECT
/AUTO SURR
SIGNAL
SELECT
LISTENING MODE
3 You can also switch off the sleep timer simply by switching off the receiver.
RECEIVER CONTROL
SHIFT
CH CH
LEVEL
SLEEP
STANDARD ADV.SURR
DIALOG E INPUT ATT
STEREO
MIDNIGHT/
LOUDNESS
EFFECT
/CH SEL
ACOUSTIC
EQ
Off
30 min 60 min
90 min
VSX_815-915.book.fm 42 ページ ２００４年１２月８日 水曜日 午後４時３分