Pioneer 915 Stereo Receiver User Manual


 
Listening to your system06
38
En
Choosing the input signal
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
1
1 Press
SIGNAL SELECT
on the front panel
to select the input signal corresponding to the
source component.
Press repeatedly to select between:
AUTO
– This automatically switches to
DIGITAL
if a digital source is detected,
otherwise it remains on
ANALOG
.
ANALOG
– Selects the analog inputs.
DIGITAL
– Selects the digital input.
When set to
DIGITAL
or
AUTO
,
2
DIGITAL
lights when a Dolby Digital signal is input, and
DTS
lights when a DTS signal is input.
Note
1• This receiver can only play back Dolby Digital, PCM (32kHz–96 kHz), WMA9 Pro and DTS digital signal formats. With other
digital signal formats, set to
ANALOG
.
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (page 15) and set the signal input to
DIGITAL
.
• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
STANDARD
ADVANCED
SURR
ST/DIRECT
/AUTO SURR
SIGNAL
SELECT
LISTENING MODE
VSX_815-915.book.fm 38 ページ 2004年12月8日 水曜日 午後4時3分