43
English
The DVD player does not start playback.
Cannot activate some features, such as
Angles, Subtitles, or multi-language
Audio.
There is no sound from the centre and
surround speakers.
Radio reception is poor.
The remote control does not function
properly.
The timer is not working.
The display panel is dark.
Low hum or buzz sound.
– Insert a readable disc with the playback side
facing down.
– Check the disc type, colour system and region
code.
– Check for any scratches or smudges on the
disc.
– Press SYSTEM SETUP to turn off the setup
menu screen.
– Change the rating level.
– Moisture has condensed inside the system.
Remove the disc and leave the system turned
on for about an hour.
– The features may not be available on the DVD.
– Changing the language for the sound or subtitle
is prohibited on the DVD.
– Make sure the centre and surround speakers
are connected correctly.
– Press SURROUND button to select a correct
surround sound setting.
– Make sure the source you are playing is
recorded or broadcast in surround sound
(DTS, Dolby Digital, etc.).
– If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
– Increase the distance between the system and
your TV or VCR.
– Tune in to the correct frequency.
– Place the antenna farther away from any
equipment that may be causing the noise.
– Select the source (DISC or TUNER, for
example) before pressing the function button
(ÉÅ, S ,
T).
– Reduce the distance between the remote
control and the system.
– Replace the batteries with new ones.
– Point the remote control directly toward the
IR sensor.
– Check that the batteries are loaded correctly.
– Set the clock correctly.
– Press and hold CLOCK•TIMER to switch on
the timer.
– Press DIM again.
– Place the DVD system as far away as possible
from electrical devices that may be causing
interference.
Problem
Solution
Troubleshooting