18
English
Step 1: Inserting batteries into
the remote control
1
3
2
1 Open the battery compartment.
2 Insert two batteries type R06 or AA, following
the indications (+-) inside the
compartment.
3 Close the cover.
Using the remote control to operate
the system
1 Aim the remote control
directly at the remote sensor
(iR) on the front panel.
2 Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TV/AV, TUNER).
3 Then select the desired
function (for example ÉÅ,
S,
T).
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to be
used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
The clock can be set in either 12-hour or
24-hour mode ("12:00 AM" or "00:00" for
example).
CLOCK•TIMER
CLOCK•TIMER
SEARCH
PROG
CLOCK•TIMER
2
3
5
4
6
SELECT CLOCK OR TIMER
CLOCK
01:38 PM
13:38
13:38
1 Press STANDBY ON to switch on the DVD
system.
2 Press and hold CLOCK•TIMER until
"SELECT CLOCK OR TIMER" appears.
3 Press T (if necessary) to change the display
to "CLOCK", then press CLOCK•TIMER
again to confirm.
4 Press S / T to set the minutes and
hours. To increase the speed, hold down
S / T.
➜ The changes in minutes will roll over to the
hours.
5 Press PROG to change between 12-hour and
24-hour clock mode.
6 Press CLOCK•TIMER again to store the
setting.
➜ The clock will start working.
To view the clock time in any active
mode
● Press CLOCK•TIMER.
➜ The clock will display for a few seconds.
Notes:
– If the DVD system is disconnected from the
power supply, it will erase the clock setting.
– If you do not press any buttons within 90
seconds, the system will exit clock setting mode.
STANDBY-ON
iR SENSOR
DISC 1
DISC 2
DISC 3
DISC 4
DISC 5
DISC 1 DISC 2 DISC 3
OPEN•CLOSE
123
456
789
0
REPEATREPEATDISC SKIP
DISC MENU
PROGRAM
SYSTEM MENU
SEATING ZOOM
PREV NEXT
SURR.
SOUND
VOL
OK
TV/AV
DISC/
MEDIA
TUNER
AUX/DI
STOP PLAY/PAUSE
buttons on
front panel
DVD system’s
display panel
Getting Started