Filter
Top Products
29
LTC 2600 Series Section 5 Enhanced Model Functions
LED Display
Certain keys have an LED indicator to light up or flash to indicate that the function is either enabled or in the
alarm state. The keys that are tied to an LED are: Cameras 1 -- 16, ALT ,ACT ,ALM . The operation of
these LEDs is identical to those on the front panel of the multiplexer
Numeric Keypad
The numeric keypad is designed to serve three purposes: selecting cameras, selecting cameos, and numeric entry.
The operation of the numeric keypad keys is identical to the multiplexer front panel.
Additional Function Keys
The system keyboards contain additional function keys not available on the front panel of the multiplexer. These
are:
Allplex Selection - (Requires two-key combination: "Allplex" + Select ) then #, then SELECT key to select
new Allplex number, and the system accepts only valid Allplex number 1 through 30.
SET - Set is a preposition function of a AutoDome or Pan/Tilt and Zoom lens. Press SET to record a preset scene
at remote camera site. (up to 99 presets can be recorded for Philip’s R/D or AutoDome.)
Set a preset function of a camera: Press Full then camera number (1-16). Using the joystick to move
the camera to the scene that you want to store then press SET (1-99) then Select
.
SHOT - Press SHOT to call up a preset scene at remote camera site.
Call up a preset function of a camera: Press SHOT (1-99) then Select .
AUX+ - Press AUX+ to select a receiver/driver auxiliary function at the camera location.
AUX- - Press AUX- to deselect any receiver/driver auxiliary functions currently in the 'ON' state.
(Note: Refer to Philips R/D or AutoDome Instruction Manual for Auxiliary function)
MultiKey Access Functions
Simultaneously Press
QUAD + CAMEO + Allplex: Set the keyboard user level to NO ACCESS.
QUAD + CAMEO + ALT: Set the keyboard user level to LIMITED ACCESS.
QUAD + ENTER + ENLARGE: Set the keyboard user level to FULL ACCESS.
VCR Control
VCR + SELECT - To toggle the VCR CONTROL mode ON and OFF.
Use the following keys for VCR functions:
VCR Function Press Key
RECORD REC/SET
PLAYBACK PLAY/SHOT
STOP ZOOM
PAUSE FREEZE
FAST FORWARD CAMEO/>
FAST REWIND FULL/<
Allplex + SELECT - To switch control to another multiplexer.
Allplex + ALT - To Enter and Exit the keyboard TEST mode.
Pan/Tilt Control
The pan/tilt function is controlled by the joystick located on the right side of the keyboard (or four directional keys
on the LTC 2601). Move it in any one of eight directions to make the camera indicated by the number in the
camera display tilt up or down, pan left or right, or move diagonally. The joystick of the LTC 2602 keyboard is also
used to provide zoom control by rotating the knob in either a clockwise or counterclockwise direction.
Lens Control - The lens control keys are located on the right side of the keyboard. Push to make the lens zoom in
or out, focus near or far, and open or close the iris (on applicable lenses). Zoom and focus may be operated
simultaneously. For the LTC 2602 keyboard, the zoom function is controlled by rotating the knob on the joystick.