8
MCV250/21-1
English
Preparations
Rear connections
The type plate is located at the rear of the
system.
A Power
Before connecting the AC power cord to the
wall outlet, ensure that the following are done;
– If your system is equipped with a
Voltage Selector, set the VOLTAGE
SELECTOR to the local power line
voltage.
– All other connections have been made.
WARNING!
–For optimal performance, use only the
original power cable.
–Never make or change any connections
with the power switched on.
To avoid overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it (not available for all versions).
VOLTAGE
SELECTOR
110V-
127V
220V-
240V
B Antennas Connection
MW Antenna
Connect the supplied MW loop antenna to the
“AM antenna” terminal. Adjust the position of
the antenna for optimal reception.
Fix the claw
to the slot
1
2
3
MW ANTENNA
● Position the antenna as far as possible from a TV,
VCR or other radiation source.
FM Antenna
It is unnecessary to connect the FM pigtail
antenna since it is fixed to the main unit.
VOLTAGE
SELECTOR
110V-
127V
220V-
240V
Speaker
(right)
Speaker
(left)
MW loop
antenna
AC power cord
FM wire
antenna
AM ANTENNA
FM ANTENNA
AUX/CDR
R L
SPEAKERS 6Ω
R
+
–
L
LINE OUT
VIDEO OUT
IN
Television
L
R
IN
Cr
Cb
Y
A
B
C
D
pg001-pg025_FWV182_98-Eng 2006.1.4, 15:468