Filter
Top Products
21
MCV250/21-1
English
Clock/Timer
View clock
The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(CD or TUNER for example)
● Press CLOCK•TIMER (CLOCK SET on the
remote).
➜ The clock is displayed for a few seconds.
➜ If the clock has not been set, "--:--" is
displayed.
Clock setting
1 In standby or view clock mode, press
CLOCK•TIMER (CLOCK SET on the
remote) once. In other source mode, press
CLOCK•TIMER (CLOCK SET on the
remote) twice.
➜ The clock digits flash on the display panel.
➜ If the clock has not been set, "--:--" flashes
2 Press ALBUM-/+ 1/¡ (ALBUM 3/4 on
the remote) repeatedly to set the hour.
3 Press TITLE-/+ í/ë (4 / ¢ on the
remote) repeatedly to set the minute.
4 Press CLOCK•TIMER (CLOCK SET on the
remote) again to store the setting.
➜ The clock starts working.
To exit without storing the setting
● Press Çon the system.
Notes:
– The clock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
– During clock setting, if no button is pressed
within 20 seconds, the system will exit clock setting
mode automatically.
Timer setting
The system can switch on to CD or TUNER
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
1 In standby mode, press and hold
CLOCK•TIMER for more than two seconds
(or press TIMER on the remote) to select timer
mode.
➜ The current source and timer digits flash on
the display panel.
➜ If the timer has not been set before, "--:--"
flashes.
pg001-pg025_FWV182_98-Eng 2006.1.4, 15:4621