Filter
Top Products
19
MCV250/21-1
English
Radio Reception
Tuning to radio stations
1 Select TUNER source.
2 Press BAND (TUNER on the remote) to
select the desired waveband : FM or MW.
3 Tu rn the TUNING control knob to tune to a
desired radio frequency.
Ta pe Operation/Recording
IMPORTANT!
– Before playing a tape, check and tighten
slack tape with a pencil. Slack tape may get
jammed or may burst in the mechanism.
– C-120 tape is extremely thin and is easily
deformed or damaged. It is not
recommended for use in this system.
– Store the tapes at room temperature and
do not put them too close to a magnetic
field (for example, a transformer, TV or
speaker).
Ta pe playback
1 Select TAPE source.
2 Open the tape key flap marked “OPEN2” on
the front panel.
3 Press STOP•OPENÇ0 to open the tape
door.
MHz
CD FM
4 Insert a recorded tape and close the tape door.
● Load the tape with the open side downward
and the full spool to the left.
5 Press PLAY 2 to start playback.
● The key is automatically released at the end of a
tape, except if PAUSE; has been activated.
6 To pause, press PAUSE;. Press again to
resume.
7 By pressing SEARCH à or á on the system
fast winding of tape is possible in both directions.
8 To stop the tape, press STOP•OPENÇ0.
Notes:
– The sound source cannot be changed while
playing or recording a tape.
– The system will change to the tape mode from
any other active mode as long as you press down
PLAY 2.
pg001-pg025_FWV182_98-Eng 2006.1.4, 15:4619