Philips DR500 Satellite Radio User Manual


 
DR500 (E-15)
Rev. C 10/94
DR500 System Components
The DR500 Digital Audio Satellite Receiver is a digital audio stereo decoder that easily integrates with
most stereo or monaural amplifier systems.
DR500 Digital Audio Satellite Receiver
The DR500 is the master receiver that connects to the satellite dish and your stereo or monaural amplifier
system.
DR500 Front Panel
The front panel of the DR500 is used to turn the DR500 on and off and manually select music channels.
The front panel consists of:
Power selector turns the DR500 on and off
When the DR500 is Off, a small green light appears on the front panel, indicating
that the DR500 is able to receive any information from the DMX/DBS National
Authorization Control Center.
Music channel selectors allow you to tune to the next higher Ù or lower Ú channel
If remote channel selection is preferred, use either the DMR-22 or DMR-28 DMX/DJ
Remote Controls.
Front panel display shows the current channel selection as well as other DR500
information
Stereo/Mono A/Mono B indicators - illuminates green to indicate either a stereo channel,
or one of two mono subchannels.
Sync indicator illuminates green when the DR500 Receiver has locked onto the
satellite
Authorized indicator illuminates green when you are authorized to receive the current
channel
LNB PWR illuminates green to indicate LNB power is enabled. No illumination
indicates LNB power is disabled. Blinking indicates a problem with the LNB power
supply. (For more information, refer to Section 5: Maintenance and Troubleshooting.)