Filter
Top Products
17
Selecting/Changing CHANNEL:
NOTE: In order for the receiver to recognize that a frequency is occupied,
make sure all transmitters that are to be used are powered up.
Press the "MENU" button until the "G/CH" function is selected. This will be
indicated by a block that will appear around the selected function located in
the upper right corner of the display.
Press the "SCAN" ▼ button once and the Channel Number on the
display will start flashing. Pressing the "SCAN" button again will start the
AutoScan process for that group. The unit will search for a channel that is not
experiencing interference and stop on that channel. If the channel number
keeps scrolling by, this means that all channels in that particular group are
experiencing interference. You should select another group and repeat the
process. Once you have found a channel, then press the "MENU" button to
save and escape the function.
(b) FREQ: Indicates the frequency currently in use. There are 100 channels, each
with its own designated frequency.