Filter
Top Products
22 208143 REV - Operations Manual, HPA3, Mini Compact Outdoor SSPA
4. Bring the unit up tight under the boom (with the long axes parallel), sliding the All-Thread
studs past the sides of the boom to show above the boom top. Place the remaining pieces
of Uni-Strut (Item 2) open channel down across the boom onto the protruding All-Thread
stud ends. Secure firmly with a flat washer (Item 6), lock washer (Item 4) and 1/2” nut
(Item 5) on each of the four All-Thread stud ends. Looking from the end of the boom, the
mounted unit should look as shown in Figure 2-5.
5. Connect the signal input, output, communication cables and power to the Mini Compact
Outdoor SSPA unit as directed elsewhere in this manual.
STATUS
SSPA
LINK
J5
ETHERNET READY
M & C
J4
SWITCH
J6
J1
RF IN
Figure 2-5: Mount Unit to Antenna Boom