Filter
Top Products
RQTX0064
6
Simple Setup
Notes on speaker use
≥Use only supplied speakers
Using other speakers can damage the unit, and sound quality will be
negatively affected.
≥You can damage your speakers and shorten their useful life if you play
sound at high levels over extended periods.
≥Reduce the volume in the following cases to avoid damage:
– When playing distorted sound.
– When the speakers are reverberating due to a record player, noise
from FM broadcasts, or continuous signals from an oscillator, test
disc, or electronic instrument.
– When adjusting the sound quality.
– When turning the unit on or off.
If irregular coloring occurs on your television
The front and center speakers are designed to be used close to a
television, but the picture may be affected with some televisions and
setup combinations.
If this occurs, turn the television off for about 30 minutes.
The demagnetizing function of the television should correct the problem.
If it persists, move the speakers further away from the television.
Caution
≥Do not touch the front netted area of the speakers. Hold by the sides.
e.g. Center speaker
≥Do not stand on the base. Be cautious when children are near.
e.g. Front speaker
∫ Attaching to a wall
You can attach all of the speakers (except subwoofer) to a wall.
≥
The wall or pillar on which the speakers are to be attached should be
capable of supporting 10 k
g
(22 lbs) per screw. Consult a qualified
building contractor when attaching the speakers to a wall. Improper
attachment may result in damage to the wall and speakers.
1 Drive a screw (not included) into the wall.
2 Fit the speaker securely onto the screw(s) with the hole(s).
∫ Fitting speaker stands (not included)
(except front speakers and subwoofer)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥The stands must be able to support over 10 kg (22 lbs).
≥The stands must be stable even if the speakers are in a high
position.
∫ Reattaching the front speaker cable
Caution
≥The main unit and supplied speakers are to be
used only as indicated in this setup. Failure to
do so may lead to damage to the amplifier and/
or the speakers, and may result in the risk of
fire. Consult a qualified service person if
damage has occurred or if you experience a
sudden change in performance.
≥Do not attempt to attach these speakers to
walls using methods other than those
described in this manual.
Speaker installation options
‰7.0 to 9.4 mm
(
9
/32q to
11
/32q)
4 to 6 mm (
5
/32q to
1
/4q)
Wall or pillar
‰4.0 mm (
5
/32q)
At least 30 mm (1
3
/16q)
Front speaker
Attach to a wall without the
base and the stand
Center speaker
e.g. [PT950] [PT953]
Surround speaker
190 mm
(7
15
/32q)
384 mm
(15
1
/8q)
Speaker stand
(not included)
Plate thickness plus
7 mm to 10 mm
(plus
9
/32q to
13
/32q)
e.g. Center speaker
5 mm (
3
/16q), pitch 0.8 mm (
1
/32q)
Metal screw holes
For attaching to
speaker stands
60 mm (2
3
/8q)
Insert the cable from
the bottom.
Pull out the cable
through the hole.
Leave about
80 mm (3
5
/16z)
Positioning
0064 En_p03-15.fm Page 6 Tuesday, February 6, 2007 6:04 PM