Filter
Top Products
RQTX0064
4
Simple Setup
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥For assembly, use a Phillips-head screwdriver.
≥There is no difference between the right and left speakers and stands.
≥For optional wall mount, refer to page 6.
∫ Preventing the speakers from falling
≥You will need to obtain the appropriate screw eyes to match the
walls or pillars to which they are going to be fastened.
≥Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result in damage to the wall or speakers.
Speaker assembly option
step
1
Assembling the front speakers
Make sure you have all the indicated components before starting assembly, setup, and connection.
2 Front speakers 2 Stands (with cable) 2 Bases
8 Screws
Tighten securely.
Slide into the groove.
Position the cable
between the ridges.
Tighten securely.
Press into the groove.
Insert the wire fully.
i: White
j: Blue
Push !
Leave about 80 mm (3
5
/16z)
Leave about 100 mm (3
15
/16z)
You can remove and use the cable from
the stand. To reattach the cable, refer to
page 6.
Insert the wire fully.
i: White
j: Blue
Push !
Tighten securely.
Press into the groove.
Thread the speaker cable through
the base.
Attach the speaker.
String (not included)
Thread from the wall to the speaker and tie tightly.
Rear of the speaker
Wall
Approx.
150 mm
(5
29
/32z)
Screw eye
(not included)
Assembling the front speakers
0064 En_p03-15.fm Page 4 Wednesday, December 27, 2006 11:00 AM