Filter
Top Products
4
RQT7972
Simple setup
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥For assembly, use a Phillips-head screwdriver.
≥Make sure you have all the indicated components before starting assembly, setup, and connection.
≥There is no difference between the right and left speakers and pipes.
[HT730] [HT733]
You can use the front speakers without assembling with the stands. In this case, attach the included
rubber pads to the base of the speakers. This prevents vibration from causing the speakers to move
or fall over. Use 3 or 4 pads per speaker.
1 Attach the pipes to the bases.
1 Insert pipe B.
2 Secure pipe B to the base.
Ensure the screws are securely fastened.
2 Assemble the pipes.
1 Thread the speaker cable from pipe A through pipe B and
the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the pipe, and then pull
the rest of the cable through the base.
2 Join pipe A to pipe B.
3 Secure the pipes.
Ensure the screws are securely fastened.
3 Attach the pipes to the speakers.
Slot the screw head in between the 2 stoppers of the speaker
groove.
Ensure the pipe is fastened on straight by gradually tightening the
right and left screws alternately until fully tightened.
To prevent a short-circuit, do not cover the connection
terminals with the pipe.
4 Connect the speaker cables.
5 Secure the speaker cables to the bases.
STEP1
Front speaker assembly
The supplied stands are specially designed for
attachment to Panasonic SB-FS730, SB-FS930 or
SB-PF920 front speakers. Use only as indicated in
this setup.
2 Front
speakers
2 Bases
≥2kpipe A
(with cable)
≥2kpipe B
4 Pipes 4 Washer
screws
4 Small
screws
4 Bracket
screws
2 Brackets Sheet of
rubber pads
Match these holes when you
insert the pipe.
Base
Pipe B
Washer screws
Phillips-head screwdriver
(not included)
Cable
Pipe B
Cable
Pipe A
Pipe B
Small screws
Pipe A
Pipe B