Filter
Top Products
Advanced Operations
En-48
Operating
procedure
(➔ page 44)
Here you can adjust the level of each speaker with
the built-in test tone so that the volume of each
speaker is the same at the listening position.
Note
• These settings cannot be calibrated in either of the
following cases:
–A pair of headphones is connected.
–The “Audio TV Out” setting is set to “On” (➔ page 53).
–“HDMI CEC (RIHD)” is set to “On” (➔ page 52) and
you’re listening through your TV speakers.
–The AV receiver is muted.
■ Left, Center
*1
, Right, Surround Right, Surround
Left
`–12 dB to 0dB
to +12 dB in 1 dB steps.
■ Subwoofer
*1
`–15 dB to 0dB to +12 dB in 1 dB steps.
Note
• Speakers that you set to “No” or “None” in “4. Sp Config
(Speaker Configuration)” (➔ page 46) cannot be selected.
*1
For the center speaker and subwoofer, the level settings
made by using the Quick Setup are saved in this menu
(➔ page 42).
Tip
• If you’re using a handheld sound level meter, adjust the
level of each speaker so that it reads 75 dB SPL at the
listening position, measured with C-weighting and slow
reading.
With the Audio Adjust functions and settings, you can
adjust the sound and listening modes as you like.
Multiplex/Mono
■ Multiplex
Input Ch (Mux)
`Main
`Sub
`Main/Sub
This setting determines which channel of a stereo
multiplex source is output. Use it to select audio
channels or languages with multiplex sources,
multilingual TV broadcasts, and so on.
■ Mono
Input Ch (Mono)
`Left+Right
`Left
`Right
This setting specifies the channel to be used for
playing any 2-channel digital source such as Dolby
Digital, or 2-channel analog/PCM source in the Mono
listening mode.
Dolby
■ PL II Music (2ch Input)
These settings apply to only 2-channel stereo
sources.
Panorama
`On
`Off
With this setting, you can broaden the width of the
front stereo image when using the Dolby Pro Logic II
Music listening mode.
Dimension
`–3 to 0
to +3
With this setting, you can move the sound field
forward or backward when using the Dolby Pro Logic
II Music listening mode. Higher settings move the
sound field backward. Lower settings move it forward.
If the stereo image feels too wide, or there’s too much
surround sound, move the sound field forward to
improve the balance. Conversely, if the stereo image
feels like it’s in mono, or there’s not enough surround
sound, move it backward.
Center Width
`0 to 3
to 7
With this setting, you can adjust the width of the
sound from the center speaker when using the Dolby
Pro Logic II Music listening mode. Normally, if you’re
using a center speaker, the center channel sound is
output from only the center speaker. (If you’re not
using a center speaker, the center channel sound will
be distributed to the front left and right speakers to
create a phantom center.) This setting controls the
front left, right, and center mix, allowing you to adjust
the weight of the center channel sound.
6. Level Cal (Level Calibration)
This setting is set automatically by
Audyssey MultEQ
®
Room Correction and Speaker
Setup function (➔ page 21).
7. Audio Adjust