Filter
Top Products
Turning On & Basic Operations
En-22
1
Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV
receiver is connected.
2
Set the speaker setup microphone at the Main
Listening Position , and connect it to the
SETUP MIC jack.
The speaker setting menu appears.
Note
• The on-screen menus appear only on a TV that is
connected to HDMI OUT. If your TV is connected to
other video outputs, use the AV receiver’s display
when changing settings.
3
When you’ve finished making the settings,
press ENTER.
Perform the “4. Sp Config (Speaker
Configuration)” according to your speaker
configuration:
–Subwoofer (➔ page 46)
If you use a powered subwoofer(s), go to step 4.
If not, go to step 5.
Speaker setup microphone
SETUP MIC jack
Subwoofer Yes
MultEQ: Auto Setup
Audyssey
4
Adjust the subwoofer volume level to 75 dB,
and then press ENTER.
Test tones are played through the subwoofer.
Use the volume control on the subwoofer.
Note
• If your subwoofer does not have a volume control,
disregard the displayed level and press ENTER to
proceed to the next step.
• If you set the subwoofer’s volume control to its
maximum and the level displayed is lower than 75 dB,
leave the subwoofer’s volume control at its maximum
and press ENTER to proceed to the next step.
5
Use / to select “Audyssey Quick Start” or
“Audyssey MultEQ Full Calibration”, and then
press ENTER.
6
Press ENTER.
Audyssey MultEQ
®
Room Correction and
Speaker Setup starts.
Test tones are played through each speaker as
Audyssey MultEQ Room Correction and Speaker
Setup runs. This process takes a few minutes.
Please refrain from talking during
measurements and do not stand between
speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey MultEQ Room Correction and
Speaker Setup, unless you want to cancel the
setup.
If you select “Audyssey Quick Start”, you will go
to step 9.
7
Place the speaker setup microphone at the
next position, and then press ENTER.
Audyssey MultEQ performs more
measurements. This takes a few minutes.
8
When prompted, repeat step 7.
9
Use / to select an option, and then press
ENTER.
The options are:
`Save:
Save the calculated settings and exit
Audyssey MultEQ Room Correction and
Speaker Setup.
`Cancel:
Cancel Audyssey MultEQ Room Correction
and Speaker Setup.
Tip
• You can view the calculated settings for the speaker
configuration, speaker distances, and speaker levels
by using / .
10
Use / to select a target, and use / to
change the setting.
After the results of Audyssey MultEQ have been
saved, the menu will display the “Audyssey”
(➔ page 49), “Dynamic EQ” (➔ page 49),
“Dynamic Volume” (➔ page 50) settings.
Note
• When “Audyssey Quick Start” has been used for
measurement, “Audyssey” cannot be selected.
• These settings are applied to all input selectors.
11
Press ENTER.
12
Disconnect the speaker setup microphone.
Subwoofer : Yes
Front : Small
Center : Small
Surround : Small
Crossover : 100Hz
Save
Cancel
MultEQ: Auto Setup
Audyssey
<- Review Speaker Configuration ->