Filter
Top Products
Advanced Operations
En-42
Operating
procedure
(➔ page 41)
You can change various audio settings from the
Quick Setup (➔ page 41).
Note
• These settings are not available in either of the following
cases:
–The “Audio TV Out” setting is set to “On” (➔ page 53).
–“HDMI CEC (RIHD)” is set to “On” (➔ page 52) and
you’re listening through your TV speakers.
Tone Control
■ Bass
`–10 dB to 0dB
to +10 dB in 2 dB steps
You can boost or cut low-frequency sounds
output from the front speakers.
■ Treble
`–10 dB to 0dB
to +10 dB in 2 dB steps
You can boost or cut high-frequency sounds
output from the front speakers.
You can adjust the bass and treble for the front
speakers, except when Direct or Pure Audio
(European, Australian and Asian models) listening
mode is selected.
Operating on the AV receiver
Phase Matching Bass
■ PM Bass
`Off
`On
From the warm low notes produced by a cello to the
deep frequencies of electronic music, a good audio
system should be able to deliver plenty of bass
resonance.
While traditional enhancement systems effectively
boost low-frequency sound, they are often prone to
the effects of phase shifting, which can overwhelm
mid-range frequencies and muddy the sound. Our
Phase-Matching Bass Boost technology effectively
preserves mid-range clarity-allowing vocals and
strings to shine-while maintaining a smooth, powerful
bass response at all volume levels.
Note
• The Phase Matching Bass is disabled when the Direct or
Pure Audio (European, Australian and Asian models)
listening mode is selected.
• If the “Subwoofer” setting is set to “No”, this setting is fixed
to “Off”.
Operating on the AV receiver
Speaker Levels
■ Subwoofer Level
`–15 dB to 0dB
to +12 dB in 1 dB steps
■ Center Level
`–12 dB to 0dB to +12 dB in 1 dB steps
You can adjust the volume of each speaker while
listening to an input source.
These temporary adjustments are cancelled when the
AV receiver is set to standby. To save the setting you
made here, go to “6. Level Cal (Level Calibration)”
(➔ page 48) before setting the AV receiver to
standby.
Note
• You cannot use these function while the AV receiver is
muted.
• These settings cannot be used while a pair of headphones
is connected.
• Speakers that are set to “No” or “None” in “4. Sp Config
(Speaker Configuration)” (➔ page 46) cannot be adjusted.
Audyssey
®
■ Audyssey
See “Audyssey” in “8. Source Setup” (➔ page 49).
■ Dynamic EQ
See “Dynamic EQ” in “8. Source Setup” (➔ page 49).
■ Dynamic Volume
See “Dynamic Volume” in “8. Source Setup”
(➔ page 50).
Note
• These technologies can be used when all the following
conditions are met:
–Room Correction and Speaker Setup is completed. Note
that “Audyssey” requires the “Audyssey MultEQ Full
Calibration” method.
–Any listening mode other than Direct or Pure Audio
(European, Australian and Asian models) is selected.
–A pair of headphones is not connected.
• The setting is stored individually for each input selector.
Using the Audio Settings of Quick
Setup
1
Press TONE repeatedly to select either “Bass”
or “Treble”.
2
Use – and + to adjust.
1
Press TONE repeatedly to select “PM Bass”.
2
Use – and + to change the setting.