Filter
Top Products
Advanced Operations
En-46
Operating
procedure
(➔ page 44)
If you connect a video component to a component
video input, you must assign that input to an input
selector. For example, if you connect your Blu-ray
Disc/DVD player to COMPONENT VIDEO IN 2, you
must assign “IN2” to the “BD/DVD” input selector.
Here are the default assignments.
■ BD/DVD, CBL/SAT, GAME, PC, AUX, TV/CD
`IN1, IN2:
Select the input to which the component has
been connected.
`-----:
Select if you’re not using the COMPONENT
VIDEO OUT.
If you connect a component to a digital audio input,
you must assign that input to an input selector. For
example, if you connect your CD player to the
COAXIAL IN 1, you must assign “COAXIAL1” to the
“TV/CD” input selector.
Here are the default assignments.
■ BD/DVD, CBL/SAT, GAME, PC, AUX, TV/CD
`COAXIAL1, COAXIAL2, OPTICAL:
Select the input to which the component has
been connected.
`-----:
Select if the component is connected to an
analog audio input.
Note
• When an HDMI IN is assigned to an input selector in
“HDMI Input” (➔ page 45), the same HDMI IN will be set
as a priority in this assignment. In this case, if you want to
use the coaxial or optical audio input, make the appropriate
selection in the “Audio Selector” (➔ page 51).
• Supported sampling rates for PCM signals (stereo/mono)
from a digital input (optical and coaxial) are
32/44.1/48/88.2/96 kHz/16, 20, 24 bit.
Here you can check the settings made by
Audyssey MultEQ Room Correction and Speaker
Setup function, or set them manually, which is useful
if you change one of the connected speakers after
using Audyssey MultEQ Room Correction and
Speaker Setup function.
This section explains how to specify which speakers
are connected and their sizes.
For speakers with a cone diameter larger than 6-1/2
inches (16 cm), specify Large (full band). For those
with a smaller diameter, specify Small (default
crossover 100Hz).
The crossover frequency can be changed in
“Crossover (Crossover Frequency)” (➔ page 47).
Note
• These settings are not available in either of the following
cases:
–A pair of headphones is connected.
–The “Audio TV Out” setting is set to “On” (➔ page 53).
–“HDMI CEC (RIHD)” is set to “On” (➔ page 52) and
you’re listening through your TV speakers.
■ Subwoofer
`Yes
`No
2. Component (Component Video
Input)
Input selector Default assignment
BD/DVD IN1
CBL/SAT IN2
GAME -----
PC -----
AUX -----
TV/CD -----
3. Digital Audio (Digital Audio Input)
Input selector Default assignment
BD/DVD COAXIAL1
CBL/SAT COAXIAL2
GAME -----
PC -----
AUX -----
TV/CD OPTICAL
4. Sp Config (Speaker Configuration)
Some of the settings in this section are set
automatically by Audyssey MultEQ
®
Room
Correction and Speaker Setup function
(➔ page 21).
Cone diameter