Filter
Top Products
Advanced Settings
31
Setting Item Default Value Setting Details
Subwoofer 1 12.0 ft/3.60 m Specify the distance between each speaker and the
listening position.
Subwoofer 2 12.0 ft/3.60 m Specify the distance between each speaker and the
listening position.
Height 1 Left 9.0 ft/2.70 m Specify the distance between each speaker and the
listening position.
Height 1 Right 9.0 ft/2.70 m Specify the distance between each speaker and the
listening position.
Height 2 Right 9.0 ft/2.70 m Specify the distance between each speaker and the
listening position.
Height 2 Left 9.0 ft/2.70 m Specify the distance between each speaker and the
listening position.
r
In the following cases, the settings for "Speaker Distance" cannot be changed:
– A speaker which is set to "None" in "Speaker Configuration".
– "Subwoofer 2" if "Subwoofer" is set to "1ch".
– "Subwoofer 1" and "Subwoofer 2" if "Subwoofer" is set to "No".
– A speaker which is set to "Not Use" in "Height 1 Speakers Type" or "Height 2 Speakers Type".
r
Default values vary depending on the regions.
Level Calibration
Adjust the level of each speaker with the built-in test tone. Settings are automatically
configured if you use the Automatic Speaker Setup.
Setting Item Default Value Setting Details
Front Left 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Wide Left 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Center 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Wide Right 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Front Right 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Surround Right 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Back Right 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
r
The setting is not displayed if "Speaker
Configuration" - "Back" is set to other than
"None" and also "Back Channel" is set to other
than "1ch".
r
In the following cases, the setting cannot be
changed:
– "Powered Zone 3" is set to "Yes", and ZONE2 and
ZONE3 are set to on.
– "Front Speakers Type" is set to "Normal“ or
"Passive Subwoofer" is set to "Yes", "Powered
Zone 2" is set to "Yes" and ZONE2 is set to on.