Filter
Top Products
7
Before using this unit
Supplied accessories
Check that the following accessories are supplied with the TX-SR700/700E/600/600E.
AM loop antenna × 1
Remote controller × 1
TX-SR700/700E: RC-482M
TX-SR600/600E: RC-480M
Batteries (AA, R6 or UM-3) × 2
R
C
-
4
8
2
M
FM indoor antenna × 1
321
R
C
-
4
8
2
M
30˚
30˚
Remote control sensor
STANDBY indicator
TX-SR700/700E/
600/600E
Approx. 16 feet
(5 meters)
L
27122974
REMOTE
CONTROL
CAUTION: SPEAKER IMPEDANCE
6 OHMS MIN. /SPEAKER
ANTENNA
FM
75
AM
COAXIAL
OPTICAL
1
2
IN
IN
IN
IN
FRONT
SURR
CENTER
SUB
WOOFER
VIDEO 2
VIDEO 1
OUT
OUT
DIGITAL INPUT
VIDEO 2
DVD
MONITOR
OUT
DVD
TAPE
CD
SUBWOOFER
PRE OUT
L
R
FRONT
SPEAKERS
ZONE
2
SPEAKERS
SURROUND
SPEAKERS
CENTER
SPEAKER
R
L
R
L
FRONT
SURROUND
CENTER
ZONE 2
SURROUND
BACK
R
L
R
L
PRE OUT
R
VIDEO 3
VIDEO 1
V
12
V
TRIGGER
OUT
ZONE 2
VIDEO 3
OPTICAL
COAXIAL
DIGITAL
INPUT
IN
IN
IN
OUT
IN
DIGITAL
OUTPUT
IN
INPUT 1
INPUT 2
OUTPUT
COMPONENT VIDEO
L
R
PHONO IN
P
R
P
B
Y
GND
OUT
OUT
S
IR
IN
SURROUND
BACK
SPEAKER
AC OUTLETS
AV RECEIVER
MODEL NO.
TX
-
SR700E
120
V
VOLTAGE
SELECTOR
220-230
V
SWITCHED
TOTAL 100W MAX.
120
V
VOLTAGE
SELECTOR
220-230
V
Speaker cable label × 1
75/300 Ω antenna adapter × 1
Conversion plug × 1
(Use this plug if the power cord plug of the TX-
SR700/700E/600/600E does not fit your AC outlet.
Shape may vary depending on the area which it
was purchased.)
The following accessories may be available
depending on the area which it was purchased.
Front
Left
Front
Left
SP-B
/
Zone 2
Left
SP-B
/
Zone 2
Left
Surround
Right
Surround
Right
Surround Back
Right
Surround Back
Right
Zone 2
Right
Zone 2
Right
Front
Left
Front
Left
SP-B
/
Zone 2
Left
SP-B
/
Zone 2
Left
Front
Right
Front
Right
SP-B
/
Zone 2
Right
SP-B
/
Zone 2
Right
Front
Right
Front
Right
SP-B
/
Zone 2
Right
SP-B
/
Zone 2
Right
Surround
Right
Surround
Right
Center
Center
Center
Center
Surround
Left
Surround
Left
Surround
Left
Surround
Left
Surround Back
Right
Surround Back
Right
Zone 2
Right
Zone 2
Right
Surround Back
Left
Surround Back
Left
Zone 2
Left
Zone 2
Left
Surround Back
Left
Surround Back
Left
Zone 2
Left
Zone 2
Left
1
2
3
Speaker Cable
Setting the voltage selector
(Worldwide models only)
Worldwide models are equipped with a voltage selector so that you
can set your TX-SR700/700E/600/600E to conform with local
power supplies. Be sure to set this switch to match the voltage of the
power supply in your area before plugging in the unit.
Determine the proper voltage for your area: 220-230 V or 120 V. If
the preset voltage is not correct for your area, insert a screwdriver
into the groove in the switch and slide the switch all the way to the
top (120 V) or bottom (220-230 V), whichever is appropriate.
Installing the remote controller batteries
1. Remove the battery compartment cover by pressing it
and sliding it in the direction shown by the arrow
below.
2. Insert two AA (R6 or UM-3) batteries into the battery
compartment. Carefully follow the polarity diagram
(positive (+) and negative (–) symbols) inside the
battery compartment.
3. After the batteries are installed and seated correctly,
replace the compartment cover.
Notes:
• Do not mix new batteries with old batteries or different kinds of batteries.
• To avoid corrosion, remove the batteries if the remote controller
will not be used for a long time.
• Remove dead batteries immediately to avoid damage from corrosion.
If the remote controller does not operate smoothly, remove the old
batteries and replace them both with two new AA batteries.
Using the remote controller
Point the remote controller toward the remote control sensor. The
STANDBY indicator lights up when the unit receives a signal from
the remote controller.
Notes:
• Make sure that the remote control sensor is not subject to strong
light such as direct sunlight or inverted fluorescent light for it
may prevent proper operation of the remote controller.
• Using another remote controller in the same room or using the
TX-SR700/700E/600/600E near equipment that uses infrared
rays may cause operational interference.
• Do not put objects on the remote controller. Its buttons may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the TX-SR700/700E/600/600E behind such doors may
prevent proper remote controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.