Filter
Top Products
65
Using remote controller
Controlling an Onkyo DVD player
The connector of the Onkyo DVD player must be connected to
the TX-SR700/700E/600/600E (see page 29).
1. Press the DVD MODE button.
The DVD MODE button lights green (RC-482M) or red (RC-480M).
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Onkyo DVD player.
Operation buttons:
ON: Turns DVD player on and off
STANDBY: Turns DVD player off (Some sets may not respond to
this button. In this case, use the ON button to put the DVD player in
the standby state.)
SETUP: Displays OSD Menu of the DVD player
: Moves cursor in the OSD Menu of the DVD player
ENTER: Enter button for the OSD Menu of the DVD player
RETURN: Return button for the OSD Menu of the DVD player
TOP MENU or MENU: Displays menu screens recorded on DVD
media
DISC
: Selects disc in DVD changer
AUDIO SEL: Selects audio or language track (if recorded on the
DVD)
ANGLE: Selects camera angle (if recorded on the DVD)
SUBTITLE: Selects subtitle language (if recorded on the DVD)
SEARCH: Searches for location on disc to start playback
RANDOM: Random playback
: Chapter/Track down
: Chapter/Track up
: Play
: Stop
: Fast reverse
: Fast forward
: Pause
OPEN/CLOSE : Opens/closes disc tray
0, 1 to 9, +10: Numeric keys
You may also use the following buttons:
VOL : Adjusts volume at TX-SR700/700E/600/600E
MUTING: Activates muting function at TX-SR700/700E/600/
600E
Note:
When operating an Onkyo DVD player directly with the remote
controller without connecting the
terminals, pre-programming is
necessary (see page 67).
DVD
operation
buttons
Numeric keys
VOL
MUTING
ON STANDBY
DVD MODE
SUBTITLE
TOP MENU
RETURN
AUDIO SEL
ANGLE
ENTER,
SEARCH
SETUP
MENU
DISC