Filter
Top Products
33
ON
RCVR
MODE
STANDBY
POWER
STANDBY/ONSTANDBY/ON
• Before you plug in the TX-SR700/700E/600/600E, confirm that
all connections have been made properly.
• Turning on the power may cause a momentary power surge,
which might interfere with other electrical equipment on the
same circuit, such as computers. If this happens, use a wall outlet
on a different circuit.
(All models other than USA and Canadian models)
• The TX-SR700/700E/600/600E is shipped with the main power
(POWER) switch in the on position (
ON
). When the power
cord is plugged in for the first time, the TX-SR700/700E/600/
600E will automatically enter the standby state and the
STANDBY indicator will light (same condition after step 2
below).
Turning on the power
1. Plug the power cord into an AC wall outlet.
(USA and Canadian models)
The STANDBY indicator will light up.
(All models other than USA and Canadian models)
Press the POWER switch to set the TX-SR700/700E/
600/600E to standby state.
The STANDBY indicator will light up.
2. Press the STANDBY/ON button to turn on the TX-
SR700/700E/600/600E.
The display will light up and the STANDBY indicator will turn
off.
If you press the STANDBY/ON button again, the receiver
returns to standby state.
Connecting the power
STANDBY indicator
To wall outlet
Turning on the power from the remote controller
Before you can use the remote controller, you must perform step 1
above and place the TX-SR700/700E/600/600E in the standby state.
1. Press the RCVR MODE button.
The RCVR MODE button lights green (RC-
482M) or red (RC-480M).
2. Press the ON button to turn on the
TX-SR700/700E/600/600E (take it out
of the standby state).
To return the TX-SR700/700E/600/600E to
the standby state, press the STANDBY
button.
Turn off
Memory preservation (Other than USA and Canadian
models)
The TX-SR700/700E/600/600E does not require memory
preservation batteries. A built-in memory backup system
preserves the contents of memory (e.g., speaker settings and
surround settings) during power failures and even when the
power is turned off with the POWER switch. The backup system
is charged when the POWER switch is turned on.
The length of time that the memory will be preserved will vary
depending on the ambient climate. On the average, memory
contents are protected over a period of a few weeks after the last
time the unit has been turned off. This period may be shorter
when the unit is exposed to a highly humid climate.
Diagram for TX-SR700/700E Diagram for RC-482M
Memory preservation (USA and Canadian models)
The TX-SR700/600 does not require memory preservation
batteries. A built-in memory backup system preserves the
contents of memory (e.g., speaker settings and surround settings)
during power failures and even when the unit is unplugged. The
unit must be plugged in order to change the back-up system.
The length of time that the memory will be preserved will vary
depending on the ambient climate. On the average, memory
contents are protected over a period of a few weeks after the last
time the unit has been unplugged. This period may be shorter
when the unit is exposed to a highly humid climate.
STANDBY indicator
To wall outlet
(All models other than USA and Canadian models)(USA and Canadian models)