Filter
Top Products
21
Before Using
Connections
Other Information
Operations
CD-dubbing (System operation)
CD-dubbing (System operation)
Setting the CD dubbing mode
The MD-101A provides two CD dubbing modes:
Album dubbing and Fade Out dubbing. These
modes are applied only to CD dubbing, but not to
other operations, such as signal synchro recording.
Album dubbing: If the end of the recordable
area on the disc is reached before the track
ends, the track will be discarded. If only one
track is being dubbed, the track will not be
discarded even if it was not recorded to the end.
Fade Out dubbing:
If the end of the recordable
area on the disc is reached before the track ends,
the last portion of the recorded track will fade out.
The CD dubbing mode setting is possible only
when the MD recorder is stopped.
• When your MD-101A is configured into a
system with Onkyo Separate Collection series
components (R-801A and C-701A), you can
record via CD dubbing by pressing the CD
DUBBING button on the MD-101A.
• To perform CD dubbing, your CD player must
be connected through an optical cable to the
DIGTAL INPUT 1 terminal located on the rear
panel of the MD recorder. (Refer to the R-
801A instruction manual for more
information.)
• For the normal recording procedure, see
“Analog Recording” on page 24 or “Digital
Recording” on page 27.
Note
• When “Protected” is shown in the display, it
indicates that the record-protect tab of the MD
is open. Before starting the recording procedure,
close the tab. (See page 34.)
• If you try Fade Out dubbing on the MD with a
short recordable time remaining, the song may
not fade out correctly.
1 Load the CD in the CD player.
See the C-701A CD player instruction
manual for information on loading CDs.
2 Load a recordable MD in the MD-
101A.
To check the time remaining for recording...
When the MD recorder is stopped,
pressing the DISPLAY button changes the
display as follows.
The number of tracks on MD and its total
recorded time
↓
Remaining recording time on MD
↓
Disc name (“No Name” when not set)
To delete recorded data on the disc to make
new recordings...
First delete all data on the disc, then start
recording. (See page 36.)
MINIDISC
RECORDER
DISC LOADIING MECHANISM
DISPLAY
MD
-
101A
STANDBY
/
ON
STANDBY
CD
DUBBING
PUSH TO
ENTER
MULTI JOG
EDIT
/
NOYES
REC
REC MODEINPUT
Total recorded time
Number of recorded
tracks on MD
Insert an MD
with the label
side up, in the
direction of
the arrow.
(Continued on the next page)