42
Naming Preset Channels
You can name FM/AM preset channels.
After you select the preset channel to name, execute
“Entering a name” as described below.
You can enter up to eight characters per name.
What characters can be entered?
You can enter the following characters:
If the unit is not in “Name In” mode, execute Steps 1 and
2 in “Entering a Name,” then follow the steps below.
1 Press / repeatedly until the
character you wish to correct or erase
flashes.
2 When correcting
Enter the desired character (or title)
following Steps 3 and 4 in “Entering a Name”
in the left column.
When erasing
Press EDIT/NO/CLEAR on the unit.
Notes:
• If you press and hold EDIT/NO/CLEAR for more
than two seconds, the CD receiver returns to the pre-
vious indication without erasing characters.
• To continue entering characters, execute Step 3 in the
left column. To complete the operation, execute Step
5.
Naming a Preset Channel
Entering a Name
1
Press EDIT/NO/CLEAR and turn
MULTI JOG until “Name In?”
appears in the display.
2
Press MULTI JOG.
3
Press DISPLAY repeatedly until
the character type you wish to
enter appears in the display.
You can select one of the following char-
acter entry modes:
•“A” for capital letters
•“a” for small letters
•“1” for numbers and symbols
1
53
2, 4
Display
The character type appears.
4
Turn MULTI JOG to select the char-
acter, then press it to enter.
Repeat this step for the next character. If
you wish to change the type of charac-
ters, repeat Step 3, then proceed with this
step.
To cancel the characters, press and hold
EDIT/NO/CLEAR for more than two
seconds.
5
Press YES/MODE after you enter
all the characters.
You will see the “Complete” message
that indicates the entry of characters is
completed.
Correcting and Erasing a Character
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7 8 9
_ @ ' < > # $ % & * = ; : + - / ( ) ?
! ’ ” , . (space) (insert)