Filter
Top Products
7
Audio equipment connections
remote control cable (supplied with every
ONKYO component that has connectors ex-
cept for the amplifier and receiver)
This unit
(CR-305TX)
MD recorder
Stereo cassette
tape deck
CD recorder
Connecting the remote control cables
If your other components are made by ONKYO and those components are equipped with connectors, you can control the -
connected components with the supplied remote controller.
• The unit must be connected in the
system hookups for control operations.
• Each component has two
connectors except for this unit. There is no difference between these connectors.
• The components may be connected in any order.
• The hookups on the previous page are necessary independently of the
system hookups.
• The illustration below is an example of a
hookup.
Note
• This is not an example of stacking the components.
What can you do with the other ONKYO components by connecting with an remote control cables?
Combination use of the unit with the stereo cassette tape deck K-505X or K-505TX, CD recorder CDR-205X or CDR-205TX, or MD recorder
MD-105X or MD-105TX enables you to operate the following convenient functions.
Note that the available components may vary according to the area.
• Remote control of the components
All the components can be operated using the supplied remote controller. (Refer to “Using the remote controller” on page 35.)
• Program timer
You can operate timer playback and recording using this unit. (With the CD recorder CDR-205X or CDR-205TX, you can operate timer
playback only.) (Refer to “Using the timer” on page 26.)
• CD dubbing
Simple CD dubbing using the CD recorder, MD recorder, or stereo cassette tape deck is possible with the pressing of a single button.
The unit begins a search for the peak level and the CD recorder, MD recorder, or stereo cassette tape deck sets the optimum recording level
to match that peak level. (Refer to CDR-205X or CDR-205TX, MD-105X or MD-105TX, or K-505X or K-505TX instruction manual for
details.)
• CD synchro recording
With the CD recorder, MD recorder, or stereo cassette tape deck in recording pause, starting CD playback causes these components to start
recording. (Refer to CDR-205X or CDR-205TX, MD-105X or MD-105TX, or K-505X or K-505TX instruction manual for details.)
Note
• Make sure the unit and each component are firmly connected with the
remote control cable, audio connection cable, and optical fiber
cable. If the connection is incomplete, the above functions does not work.
About the OPTICAL DIGITAL OUTPUT connector
• An optical digital audio input equipped MD recorder, DAT, or CD recorder may be connected with an optical fiber audio cable for digital
recording of this unit.