Filter
Top Products
14
Enjoying Audio Sources
• Before connecting the power cord, connect all your
speakers and audio components.
•Turning on the A-9355/A-9155 may cause a momen-
tary power surge, which might interfere with other
electrical equipment on the same circuit. If this is a
problem, plug the A-9355/A-9155 into a different
branch circuit.
For home electric appliances which require a measure-
ble amount of power, do not use the same wall outlet in
which the A-9355/A-9155 is plugged so that the
A-9355/A-9155 may operate under optimum condi-
tions. Allocate them another wall outlet.
Notes:
•To shut down the A-9355/A-9155 completely, set the
[POWER] switch to the OFF position ( ).
•For the sake of speaker protection, the A-9355/A-9155
waits for approximately 10 seconds after powered on
before the system becomes stable to start delivering
sound.
Powering on the whole system
This operation is available when you have Onkyo products
with STANDBY/ON function connected through
Press first the ON button on the remote controller to turn
the A-9355/A-9155 on. Press once again the ON button on
the remote controller to power on every Onkyo component
that is connected to the A-9355/A-9155 via .
Powering on the all the components at a time
that are connected to the A-9355/A-9155
With the A-9355/A-9155 powered on, press and hold the
ON button on the remote controller for more than 16 sec-
onds.The system goes Standby. Now you can power on all
the components connected to the A-9355/A-9155 at a time
by pressing the ON button on the remote controller.
•To restore the setting, use the same procedure mentioned
above.
You can select which set of speakers outputs sound, or
you can use both sets at the same time.
To output sound from the speakers connected to the
SPEAKERS A terminals, press the SPEAKERS [A]
button. The indicator above that button will light up.
To output sound from the speakers connected to the
SPEAKERS B terminals, press the SPEAKERS [B]
button. The indicator above that button will light up.
To output sound from all connected speakers, press the
SPEAKERS [A] and SPEAKERS [B] button so that
both indicators are on.
Connecting the Power Cord
Turning On the A-9355/A-9155
1
Press the [POWER] switch.
The A-9355/A-9155 retains the power
mode (on/standby) in which the ampli-
fier was the last time you turned off the
system.
Notes:
• The A-9355/A-9155 is shipped with
the [POWER] switch in the OFF
position ( ). When the power cord
is connected for the very first time or
the [POWER] switch is set to ON
() position, the A-9355/A-9155
will turn on.
• When it’s turned on, the
A-9355/A-9155 outputs no sound
for about five seconds. This allows
the circuits to stabilize.
To wall outlet
POWER
ON
STANDBY
STANDBY
indicator
A-9355/
A-9155
2
To turn the A-9355/A-9155 on,
press the [ON] button on the
remote controller.
The STANDBY indicator goes off.
To set the A-9355/A-9155 to
Standby, press the [STANDBY]
button on the remote controller.
The STANDBY indicator lights up.
Selecting Speaker Set A or B
Remote
controller
SPEAKER selector