Filter
Top Products
13
Connecting the A-9355/A-9155—Continued
Connecting Components
With (Remote Interactive), you can control your
-compatible Onkyo CD player, Tuner, and so on
with the A-9355/A-9155’s remote controller.
If you connect other Onkyo components to the
A-9355/A-9155 with the appropriate and audio
cables, you can use the following system functions.
cables are special cables solely for use with Onkyo
products (no cables are supplied with the
A-9355/A-9155).
When you set the A-9355/A-9155 to Standby, all con-
nected components will go on Standby as well (the
A-9355/A-9155’s POWER switch must be set to ON for
this to work).
Direct Change
When playback is started on an audio component con-
nected via , the A-9355/A-9155 will automatically
select that component as the input source.
Remote Control Operation
You can control all components in your system by using
the A-9355/A-9155’s remote controller. See page 8 and
9 for more information.
•To use , you must make an analog audio con-
nection between the A-9355/A-9155 and each
audio component.
Notes:
• Push each plug in all the way to make a good connec-
tion.
• A-9355: The A-9355 has two jacks. If you want
to connect two or more audio components to the A-
9355, it is advisable to connect any of two compo-
nents directly to the A-9355 for better audio quality,
in stead of linking all the components using the daisy
chain method.
• Use only dedicated cables for connections
(no cables are supplied with the
A-9355/A-9155).
• The A-9355 has two jacks. They’re all the same,
so you can use either of them.
• jacks should be connected only to Onkyo compo-
nents. Connecting them to another manufacturer’s
component may cause the A-9355/A-9155 to mal-
function.
• Some components may not support all functions.
See the manuals supplied with your other Onkyo
components for more information.
Connecting Another Component’s Power
Cord
The A-9355/A-9155 has a switched AC OUTLETS on
its rear panel. These can be used to connect the power
cord of another audio component that you intend to use
with the A-9355/A-9155.
After you power on the A-9355/A-9155, you can feed or
shut off power to the connected component by turning
on or off the remote controller switch. Use the AC outlet
of the A-9355/A-9155 to feed only components that
have no STANDBY/ON function, like Onkyo DX-7355
CD player. For Onkyo products equipped with ter-
minals that have a STANDBY/ON function, allocate a
normal outlet that is energized on a steady basis.
Note:
Do not connect any other devices than audio compo-
nents.
Caution:
Make sure that the maximum power requirement of the
component connected to the AC OUTLETS do not
exceed the capacity printed on the A-9355/A-9155’s
rear panel (100W).
Onkyo CD player
(DX-7355), etc.
A-9355/A-9155
connector
Remote control cable
connector
Onkyo Tuner, etc.
Remote Interactive
Dock, etc.
connector
A-9355