Filter
Top Products
11
Connecting the A-9355/A-9155—Continued
Connecting a Turntable
The A-9355/A-9155’s PHONO input jacks are for use
with moving-magnet (MM) type cartridges.
Use an analog audio cable to connect the
A-9355/A-9155’s PHONO L/R jacks to the audio out-
put jacks on the turntable, as shown.
If your amplifier has shorting pin plugs, remove the
shorting pin plugs before connecting your turntable.
Notes:
• If the turntable has a ground wire, connect it to
A-9355/A-9155’s GND terminal. With some turnta-
bles, connecting the ground wire may cause hum, in
which case it should be disconnected.
• If the turntable has a moving-coil (MC) type car-
tridge, you’ll need a commercially available MC
phono preamp. In this case, connect the turntable to
the phono preamp’s input, and connect the phono
preamp’s output to the A-9355/A-9155’s PHONO
L/R jacks.
Connecting a CD Player
Use an analog audio cable to connect the
A-9355/A-9155’s CD L/R jacks to the analog audio out-
put jacks on the CD player, as shown.
•Always refer to the instructions that came with the
component that you are connecting.
• Do not plug in the power cord until all connec-
tions have been properly made.
• Do not bind audio cables with power cords and
speaker cables. Doing so may adversely affect the
sound quality.
•To prevent interference, keep power cords and
speaker cables away from the tuner’s antenna.
RCA Audio Connection Color Coding
• Red connectors are used for the right channel, and
white connectors are used for the left channel.
• Push each plug in all the way to make a good con-
nection (loose connections can cause noise or
malfunctions).
Before Making any Connections
Left (white)
Right (red)
L
R
Wrong!
Right!
Audio Components
AUDIO OUT
Ground wire
ANALOG
OUT