Multiplex Technology 301 Satellite Radio User Manual


 
22
Dear customer,
Dear fellow-modeller,
We are delighted that you have decided to purchase a MULTIPLEX radio control system.
Your PROFI CAR 301 has all, what’s needed for ON- or OFF-ROAD models in 1:12, 1:10 and
1:8 scale.
Hardware, design and operation philosophy are the same as in the two „big“ radios (PROFI
CAR 403 and 707). Modifications have been made only, where required by an optimised
user-friendliness.
We wish you many hours of pleasure with your PROFI CAR.
Yours - the MULTIPLEX team
1. Safety
Radio-controlled models are not playthings!
The most important contribution to operational security and safety is your own: all
you have to do is handle your radio control system and model with due care and in a
responsible manner.
v Check all electrical and mechanical connections in the model at regular
intervals.
v Check regularly that all working parts are free-moving and devoid of slop.
v Carry out regular range checks (è 13.2, page 18).
v Before you switch on, ask other modellers at the trackside which channels
are already in.
v Extend the transmitter aerial to full length before running your model, and
check that it is firmly seated and in good condition.
v Check that you have selected the correct model memory for your model.
v Check all working systems before each run:
Are the servos moving in the correct direction?
Are the control travels set correctly?
v Are the transmitter and receiver batteries adequately charged, and in
serviceable, well maintained condition?
v Use genuine MULTIPLEX crystals, batteries and accessories exclusively.
v If any components of your receiving system are not covered by this manual,
read carefully the instructions supplied with them.
If you are in doubt about anything - don’t run your model. Check everything again in
peace and quiet, and locate and eliminate the cause. If you cannot solve the
problem, you will find your model shop and the MULTIPLEX Customer Service
department ready and willing to help you.
!!
Read the notes in Section 13. concerning using the system!