Filter
Top Products
59
Basic versionSimple version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Advanced version
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Operating learn mode
Erasing the all sources
1
Press and hold down SET and
SOURCE SEL until the LEARN
indicator blinks.
2
Press and hold down D.MODE
and press ON and STANDBY .
LEARN indicator lights.
3
Press ENTER to continue erasing.
• The SEND indicator blinks twice and
the mode returns to LEARN mode.
• To cancel the erasing operation, do
not press ENTER and simply press any
other button.
4
To return the normal mode, press SET.
NOTE
Erasing codes will return to the factory preset code, or there will leave
empty if the button has no factory preset code.
Setting the back light
Press the Light button on the side of the remote control, and the
buttons on the remote control light for 2 seconds. If the Light button
is pressed while the buttons are lit, the buttons remain lit for another
2 seconds.
• Backlight is set on in the factory settings.
n Disabling the backlight
Press and hold both SET and
STANDBY until the SEND indicator
ashes twice.
n Turning the backlight on
Press and hold both SET and ON
until the SEND indicator ashes
twice.