Marantz NR1601 Home Theater System User Manual


 
21
Advanced versionSimple version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Basic version
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Playback (Basic operation)
n Playing a Blu-ray Disc player/DVD player
(vpage22)
n Playing a CD player (vpage22)
n Playing an iPod
®
(vpage22)
n Playing a USB memory device (vpage23)
n Tuning in radio stations (vpage24)
Selecting a listening mode (Surround mode)
(vpage26)
n Selecting the input source (vpage21)
n Adjusting the master volume (vpage21)
n Turning off the sound temporarily (vpage21)
Playback (Advanced operation) (vpage35)
Important information
Before starting playback, make the connections between the different
components and the settings on the receiver.
NOTE
Also refer to the operating instructions of the connected components
when playing them.
Selecting the input source
Press the input source select button
(BD, DVD, SAT, GAME, AUX1, USB,
TV, CD, TUNE, M-XP) twice to play
back that source.
The desired input source can be selected
directly.
You can also use the following operation to select an input
source.
• Select input source “AUX2” to play back music from an audio
system connected to the AUX2 input connector.
• Select the input source “AUX2” using one of the following methods.
q “Source select ” menu (“Using the “Source Select” menu”
provided on the right)
w INPUT d f on the remote control unit (“Operating the remote
control unit” provided on the right)
e INPUT SELECTOR knob on the main unit (“Operating the main
unit” provided on the right)
n Using the “Source Select” menu
q Press AMP and then press SOURCE SEL.
Display the “Source Select” menu.
SAT
DVD
GAME
AUX1
TV
USB
CD
AUX2
TUNER
M-XPort
BD
Source Select
[ENT]:Select
[ ]:Source
The currently selected input source
is highlighted.
w Use uio p to select the input
source, then press ENTER.
The input source is set and the source
selection menu is turned off.
• When using with an iPod connected directly to the USB port of this
unit, select “USB” for the input source.
• Input sources that are not going to be used can be set ahead of time.
Make this setting at “Source Delete” (vpage52).
• To turn off the source selection menu without selecting an input
source, press SOURCE SEL again.
n Operating the remote control unit
Press INPUT d f.
• When INPUT d f is pressed, the
input source is switched in the order
shown below.
BD DVD SAT GAME
CD TV
USB
M-XPort AUX2TUNER
AUX1
n Operating the main unit
Turn INPUT SELECTOR.
• Turning INPUT SELECTOR switches
the input source, as shown below.
BD DVD SAT GAME
CD TV
USB
M-XPort AUX2TUNER
AUX1
Adjusting the master volume
Use VOLUME + – to adjust the volume.
n When the “Volume Display” setting
(vpage52) is “Relative”
GAdjustable rangeH
– – –
–80.5dB – 18.0dB
n When the “Volume Display” setting (vpage52) is
“Absolute”
GAdjustable rangeH
0.0 – 99.0
• The variable range differs according to the input signal and channel
level setting.
You can also operate via the main unit.
In this case, perform the following
operations.
Turn VOLUME to adjust the volume.
Turning off the sound temporarily
Press MUTE.
• The sound is reduced to the level set at “Mute Level” (vpage52).
• To cancel, press MUTE again. Muting can also be canceled by
adjusting the master volume.