33
Basic versionSimple version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Advanced version
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
1
Set up
the remote control unit
n Set up the operation mode
Press AMP to set the remote control
unit to amplier operation mode.
Press AMP
2
Connect the setup microphone.
3-1.Audyssey Auto Setup
MultEQ
at ear height at
Amp Assign: Normal
Front Sp. : A
F.Height : Measure
Start
Cancel
[ENT]:Select [RTN]:Back
Please place microphone
main listening position.
When the setup microphone is
connected, the following screen is
displayed.
3
Set up “Amp Assign”
Use ui to select “Amp Assign”.
3-1.Audyssey Auto Setup
MultEQ
at ear height at
Start
Cancel
[RTN]:Back
Please place microphone
main listening position.
Front Sp. : A
F.Height : Measure
Amp Assign: Normal
Set up speakers
around items indicate the settings.
This section provides the setup methods of speaker systems other than the 7.1-channel system (with surround back speakers).
For the setup methods of the 7.1-channel system with surround back speakers, see “Set up speakers (Audyssey® Auto Setup)” (vpage6) of “Simple version”.
First install and connect the speakers to this unit.
4
Use o p to select the conguration
of the connected speakers.
Normal
Set when using 9.1-channel
(Front/Center/Surround/Surround
Back/Front height/Subwoofer)
speakers.
SPKR-C
Set for connecting a tweeter of
a front speaker to the SURR.
BACK/SPEAKER C terminals and
a woofer of the front speaker to
the FRONT A terminals.
5
Set up “F. Height”
Press u to select “F. Height”.
Measure
Set to measure the front height
speakers.
Skip
Set not to measure the front
height speakers.
6
Set up “Front.Sp.”
Use ui to select “Front Sp.” and
then press
o p to select a speaker.
A
Select this to use front speaker A.
B
Select this to use front speaker B.
NOTE
If “Mesure” is selected in step 5, select “A”. If
“B” is selected, the “F.Height” measurement
cannot be performed.
7
Proceed to page 8
“
Preparation
” step 5.
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu