Filter
Top Products
60
Setting items Setting details
Display
Set the display on/off
setting.
ON : Display is always on.
Auto OFF : Display is off except when showing the status display.
OFF : Display is always off.
This can also be set by pressing DISPLAY.
Each time DISPLAY is pressed, the setting is
changed as shown below.
ON Auto Off
OFF
Setup Lock
Protect settings from
inadvertent change.
ON : Turn protection on.
OFF : Turn protection off.
When canceling the setting, set “Setup Lock” to “OFF”.
NOTE
When “Setup Lock” is set to “ON”, the settings listed below can no
longer be changed. Also, “Setup Lock!” is displayed if you attempt to
operate related settings.
•Menu operations •Channel Level
•M-DAX •Dynamic Volume
®
•HT-EQ •Display settings
System Setup
Setting items Setting details
GUI
Make the settings related to
displays on the TV screen.
Screensaver : Make screensaver settings.
•ON : The screensaver is activated during menu
display, Tuner screen display if no operation
is performed for an approximately 5-minute
continuous period. When you press uio p,
the screensaver is cancelled and the screen
before that screen saver started is displayed.
•OFF : Screensaver is not activated.
Format : Set the video signal format to be output for the TV you are using.
•NTSC : Select NTSC output.
•PAL : Select PAL output.
“Format” can also be set by the following procedure. However, the menu
screen is not displayed.
1. Press and hold the main unit’s MENU and ENTER for at least 3 seconds.
“V.Format:<PAL>” appears on the display.
2. Press the main unit’s o p and set the video signal format.
3. Press the main unit’s ENTER to complete the setting.
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
Text : Display the details of operation when switching surround mode,
input mode, etc.
•ON : Turn display on.
•OFF : Turn display off.
Master Volume : Display the master volume during adjustment.
•Bottom : Display at the bottom.
•Top : Display at the top.
•OFF : Turn display off.
When the master volume display is hard to see when superimposed
on movie subtitles, set to “Top”.
Tuner : Set the tuner screen display time when the input source is
“Tuner”.
•Always : Show display continuously.
•30s : Show display for 30 seconds after operation.
•10s : Show display for 10 seconds after operation.
•OFF : Turn display off.
Basic version
Advanced version
Information
Advanced version
vSee overleaf
BD