Filter
Top Products
26
General Functions
Turning your handset on
Ensure that your USIM card is in your handset
and the battery is charged.
Press the key.
Enter the USIM PIN code that was supplied with
your USIM card if PIN code setting is on.
After a few seconds you will be registered on
the network.
Turning your handset off
Press and hold the key until power is off.
There may be some delay while the handset
powers down.
Do not re-power the handset during this time.
Access Codes
You can use the access codes described in this
section to avoid unauthorized use of your
phone. The access codes (except PUK and
PUK2 codes) can be changed by using the
Change codes feature [Menu 3.4.3].
PIN code (4 to 8 digits)
The PIN (Personal Identification Number) code
protects your USIM card against unauthorized
use. The PIN code is usually supplied with the
USIM card. When the PIN Code Request is set
to Enable, your phone will request the PIN code
every time it is switched on. When the PIN Code
Request is set to Disable, your phone connects
to the network directly without the PIN code.
PIN2 code (4 to 8 digits)
The PIN2 code, supplied with some USIM
cards, is required to access functions such as
Fixed Dial Number. These functions are only
available if supported by your USIM card.
PUK code (4 to 8 digits)
The PUK (PIN Unblocking Key) code is required
to unlock a blocked PIN code. Contact 3
Customer Services for the code.
PUK2 code (4 to 8 digits)
The PUK2 code, is required to unlock a blocked
PIN2 code. Contact 3 Customer Services.