Filter
Top Products
Lexicon
PCM 80 User Guide
2-26
Renaming the Effect
Selecting a Bank and
Register Location
Press Load/✱ to move the asterisk to the Register Bank ID.
Renaming an effect is straightforward. With the asterisk and the cursor posi-
tioned as shown, turn ADJUST to select a new character. Press Up or Down to
select a new type of character (upper case, lower case, numeric, symbolic, or
blank). Simultaneously press Up and Down to clear all characters from the
cursor to the end of the line. Turn SELECT to reposition the cursor over another
character, and use ADJUST to change it. Continue in this manner until you have
finished entering the new name. A maximum of 12 characters (including spaces)
may be used.
✱R 0.0 available
ADJUST: Efx/Rvb X
When the asterisk is positioned in front of
the Bank ID, ADJUST or SELECT will scroll
through the available register banks.
Press Load/✱ again to move the asterisk to the register matrix location.
R ✱ 0.0 available
ADJUST: Efx/Rvb X
When the asterisk is positioned in
front of the register matrix location,
ADJUST or SELECT will scroll
through the available registers.
Once you have made all the changes you want to an effect, and have selected
a register location, press Store. If you press Store, the display will ask "Are you
sure?" (Press STORE). If you don't want to save the effect as shown, press any
button to cancel the operation. Press Store to complete the operation.
R 0.0 available
Name: ✱Prime Blue
Use ADJUST to select a new character. Turn
SELECT to move the cursor to another position.
Renaming the
ADJUST Knob Patch
R 0.0 available
ADJUST: ✱Efx/Rvb X
The name of the ADJUST Knob patch will appear here.
Use ADJUST to select a new character. Turn SELECT
to move the cursor to another position.
Press Load/✱ to select the ADJUST patch for renaming. The display will
change to show the following: