Filter
Top Products
Lexicon
5-6
PCM 80 User Guide
Reception of MIDI Program Change and Bank Select messages can be
selectively enabled/disabled from Control Mode parameter 3.0, MIDI Pgm
Change. The manner in which the PCM 80 interprets these messages is
determined by the value of this parameter as follows:
Pgm Change: Off
All Program Change and Bank select messages are ignored. Pgm+ and Pgm–
will load the next higher or lower program in the current bank.
Pgm Change : On
Program Change messages 0-49 correspond to PCM 80 Effects 0.0 -4.9 in the
current bank. Program Change messages 50—127 are ignored. Pgm+ and
Pgm– will load the next higher or lower program in the current bank.
The current bank can be changed with MIDI Bank Select Messages as follows:
0-3: Program Banks 0-3
4: Internal Register Bank
5-9: reserved
10-56: Memory Card Banks
The number of banks available on a given card will vary with card
size as follows:
Card Size # Banks
64 2
256 11
512 23
1 Meg 47
Pgm Change: Map
Program Change 0-127 can be mapped to any PCM 80 Effect in any internal or
card bank. Two 128 element maps are stored internally, additional maps may be
stored on RAM cards.
Map 0 Map 1
MIDI 0 = P0 0.0 MIDI 0 = P2 2.8
MIDI 127 = P2 2.7 MIDI 127 = R 4.9
Pgm+ and Pgm– will load the next higher or lower program in the map.
Pgm Change: Chain
Any Program Change number can be selected to load any one of ten customized
effect “chains.” Once a chain is loaded, effects in the chain are accessed by the
controller patched to Pgm + and Pgm – (program increment and program
decrement).
Program Change
Messages