Lexicon PCM 80 Stereo Amplifier User Manual


 
Lexicon
4-20
PCM 80 User Guide
4.5 ADJToFreeze ADJUST: Freeze It 0–1
Click ADJUST to create an infinite stereo loop of the input source. Click it again to stop
the loop. A little reverb is added while the loop is on. The loop size is tempo controlled.
Change it on the fly by pressing Tap while the loop is off. The preset is set to freeze 1 beat,
but you can set any rhythm you want by changing the Soft Row delay parameter values.
4.6 ADJToFreeze2 ADJUST: Freeze It 0–1
The same basic loop effect as ADJToFreeze, but the delays are set to different values
for the left and the right side. In this preset a 2 against 3 pattern will be created.
4.7 FSw2 Freeze ADJUST: Feedback 0–100
A very useful infinite delay effect. Press Tap to establish the tempo. Use ADJUST to set
the feedback level. Foot switch 2 is patched to turn infinite repeat on and off.
4.8 FSw2 Speedup ADJUST: How Long? 0–100
Footswitch 2 is patched to turn on an infinite loop while it is held down. When the foot
switch is released, the loop continues but grows shorter with every repeat until the loop
size is 0. Use ADJUST to set the amount of time it takes for the loop to shrink to nothing.
A footswitch must be connected to make this preset work.
4.9 LongestLoop ADJUST: FX Mix 0–100
This preset uses the cross-feedback path in the delay voices to create a 5-second mono
loop. Footswitch 2 is patched to turn infinite repeat off and on and, at the same time, to
change the mix from 0 % to 100 % wet. Foot switch 1 is patched to clear the delays.
ADJUST sets the reverb level for the loop. 0 = no reverb, 127 = all reverb. The Soft Row
contains the parameters for setting the master delay for the loop as well as several reverb
parameters. A footswitch must be connected to make this preset work.
Remix Effects
(P3 4.0 – P3 4.9) cont'd.