Filter
Top Products
AUTO DISTANCES
FRONT LEFT 12.0ft
CENTER 10.5ft
FRONT RIGHT 12.0ft
SIDE RIGHT 4.5ft
REAR RIGHT 0.0ft
REAR LEFT 6.0ft
SIDE LEFT 4.5ft
SUB (MONO) N/A
SUB RIGHT N/A
LFE N/A
REAR RIGHT ERROR
Configuring the MC-12 for V4 EQ
2-18
Lexicon MC-12 Controller
Step EQ DISTANCES LEVELSDISTANCES or OUTPUT LEVELS ROOM EQ
7
The AUTO DISTANCES or AUTO LEVELS screen
(shown above) opens only if there is an error
during loudspeaker distances or output levels
calibration. Otherwise, the MC-12 skips to Step
9.
This screen provides the results for each
loudspeaker:
•A value indicates that no errors occurred during
calibration.
• An ERROR indicates that, although a value
was calculated, at least one error occurred
during calibration.
Press the and arrow buttons to highlight
the desired loudspeaker. Then, press the
arrow button to view more detailed results for
the selected loudspeaker. The
DISTANCES and
OUTPUT LEVELS Results
table on the next
page describes all possible results.
The AUTO SPEAKER SETUP results screen (shown above) opens on
the on-screen display when the MC-12 finishes calibrating loudspeaker
output levels.
This screen indicates that the ROOM EQ procedure is finished. The
AUDIO CONTROLS menu ROOM EQ procedure is automatically set
to ON, and the AUDIO CONTROLS menu ROOM EQ LEVEL
parameter is automatically set to MEDIUM. These parameters can
now be used to activate and deactivate room correction and to
control the amount of room correction applied to the loudspeakers.
Refer to
Adjusting Room Correction (page 2-21).
This screen also provides the results for the DISTANCES and LEVELS
procedures:
• OK indicates that no errors occurred during calibration.
• ERROR indicates that, although a value was calculated, at least one
error occurred during calibration.
Press the and arrow buttons to highlight the desired procedure.
Then, press the arrow button to open the AUTO DISTANCES or
AUTO LEVELS screen. Follow the instructions in the column to the
left to view more detailed results for individual loudspeakers.
The ROOM EQ DONE
screen (shown above) opens
on the on-screen display
when the MC-12 finishes
applying room correction to
the loudspeakers.
This screen indicates that
the ROOM EQ procedure is
finished. The AUDIO
CONTROLS menu ROOM EQ
parameter is automatically
set to ON, and the AUDIO
CONTROLS menu ROOM
EQ LEVEL parameter is
automatically set to MEDIUM.
These parameters can now
be used to activate and
deactivate room correction
and to control the amount
of room correction applied
to the loudspeakers. Refer to
Adjusting Room
Correction
(page 2-21).
ROOM EQ DONE
PRESS V TO CONTINUE
ROOM EQ APPLIED
TO ADJUST
GO TO
AUDIO CONTROLS
AUTO LEVELS
FRONT LEFT -2.0dB
CENTER 0.0dB
FRONT RIGHT -2.0dB
SIDE RIGHT -4.5dB
REAR RIGHT -3.0dB
REAR LEFT -3.0dB
SIDE LEFT -4.5dB
SUB (MONO) N/A
SUB RIGHT N/A
LFE N/A
CENTER ERROR
AUTO SPEAKER SETUP
DISTANCES ERROR
LEVELS OK
ROOM EQ DONE
AUTO VALUES APPLIED
PRESS V TO VIEW
DETAILS