Filter
Top Products
Configuring the MC-12 for V4 EQ
2-16
Lexicon MC-12 Controller
PERFORMING AUTOMATIC CALIBRATION
AUTO SPEAKER SETUP
TEST WILL BEGIN IN
10
PRESS V TO SKIP
COUNTDOWN
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
SPEAKER SETUP
SET CROSSOVERS
CHECK MICROPHONES
AUTOMATIC
MANUAL
SET CROSSOVERS
BEFORE CALIBRATING
SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
SETUP
AUTOMATIC
SPEAKERS
10
AUTO SPEAKER SETUP
EQ DISTANCES LEVELS
ROOM EQ
DISTANCES
OUTPUT LEVELS
PLACE MICROPHONES
AROUND PREFERRED
LISTENING POSITIONS
AUTO SPEAKER SETUP
!CAUTION!
HIGH AUDIO LEVELS
YOU WILL HAVE 10 SEC
TO LEAVE THE ROOM OR
SIT QUIETLY
PRESS V TO BEGIN
COUNTDOWN
EQ DISTANCES LEVELS
ROOM EQ
DISTANCES
OUTPUT LEVELS
Step EQ DISTANCES LEVELSDISTANCES or OUTPUT LEVELS ROOM EQ
1
2
3
4
Follow the instructions in the appropriate table column below to perform the desired automatic calibration procedure.
Open the AUTO SPEAKER SETUP menu as shown above.
• The AUTO SPEAKER SETUP menu is not available unless a successful microphone check has been performed. If one of the error
messages shown to the right appears on the on-screen display, refer to
Performing the Microphone Check (page 2-8).
Press the and arrow buttons to highlight the desired automatic calibration procedure. Then, press the arrow button to select this procedure.
The !CAUTION! HIGH AUDIO LEVELS screen (shown above) opens on the on-screen display, reminding that the MC-12 outputs loud calibration noise signals
during automatic calibration. Press the arrow button to continue.
Note:
If calibration noise signals become too loud, press the arrow button to cancel automatic calibration.
The TEST WILL BEGIN IN screen (shown above) opens on the on-screen display, activating a 10-second countdown until automatic calibration begins. To skip
the countdown and begin automatic calibration, press the arrow button.
• Otherwise, the MC-12 automatically begins automatic calibration when the countdown ends. During the countdown, it is possible to leave the listening
room without affecting automatic calibration. Return to the listening room about 20 minutes later to avoid interrupting the procedure.
MIC CHECK REQUIRED
FOR AUTO CALIBRATION
NO MICROPHONES
DETECTED