Filter
Top Products
11
DC-2 Digital Controller
System
Configuration
2
System
Configuration
Restore
Factory Defaults
Although the DC-2 memory is cleared before it leaves the factory, it is good
practice to restore the factory defaults with the following procedure before
system configuration.
Turn the DC-2 OFF with the remote control. Turn the unit back ON and
immediately press and hold the MUTE button on the remote. (Make sure
you do not block the infrared receiver on the DC-2 front panel.) The display
will read:
Press ▼ to highlight RESTORE DEFAULTS, then press SELECT. This will
clear and reload all preset effects and all factory settings of Volume,
Balance, Contrast, Configuration, etc. When the message FACTORY DE-
FAULTS RESTORED is displayed, press DONE to return to normal opera-
tion.
FACTORY PRESETS MENU
EXIT
RESTORE DEFAULTS
Equalization
In the main menu, press SELECT to open the Equalization menu which
contains Bass, Treble and Tilt controls, and a Loudness parameter.
Bass and Treble level controls are provided to compensate for inconsisten-
cies in source material, rather than variations in room conditions. The BASS
LEVEL control allows a boost or cut of as much as 6dB below 250Hz. The
TREBLE LEVEL control allows a boost or cut of 6dB above 1.5kHz. To select
either control for adjustment, use ▲ or ▼ to select the control, press SELECT,
and use ▲ or ▼ to adjust the setting.
These controls do not affect the sound of rear or side speakers.
Bass and Treble Level
MAIN MENU
SETUP
EFFECT ADJUST
EQUALIZATION
DISPLAY ADJUST
EQUALIZATION MENU
BASS LEVEL
TREBLE LEVEL
TILT
LOUDNESS
-6.0 to +6.0dB
-6.0 to +6.0dB
-3.0dB to +3.0dB
ON, OFF
▲▼
Adjust with or
+0.0dB
+0.0dB
+0.0dB
ON