Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting a Component/XGA – Audio Distribution System
14
TP-46 (not shown in Figure 7).
The signal from the component video source is transmitted via the twisted
pair cable; decoded and converted to component video and outputted on the
Y, C
B/PB, CR/PR OUTPUTS RCA connectors to the component video
acceptor.
8. Connect the LINE OUT RJ-45 connector on the TP-46 to a second TP-46
unit
1
(optional).
9. Similarly, you can connect the LINE OUT RJ-45 connector on the TP-46 to
additional TP-46 units.
10. On the TP-46 underside:
• If required, adjust
2
the video output signal level and/or cable
compensation equalization level
3
• If necessary, set the HS and VS switches
4
, on the underside
1 Connect the required outputs to the second TP-46
2 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
3 If more than one TP-46 unit is connected, adjust the level and cable compensation in sequence from the first TP-46 unit
(that is connected directly to the TP-45) to the next and so on
4 By default, both switches are set down (for normal V SYNC and H SYNC polarity)