Filter
Top Products
Connecting a Component/XGA – Audio Distribution System
13
5.2 Connecting the System in Component Video Mode
To configure a TP-45/ TP-45RC/TP-46 Component/XGA – Audio
distribution system
1
in the component video mode, as the example in
Figure 7
illustrates, do the following:
1. On the TP-45 or TP-45RC, connect the following:
• A component video source (for example, a DVD player) to the
Y, Cb/Pb, Cr/Pr RCA connectors
• A digital audio source to the S/PDIF RCA connector
2
2. If necessary, set the HS and VS switches
3
, on the TP-45 underside.
3. On the TP-45, use the SELECT buttons as follows:
• Release the video SELECT button to choose the component
video input
• Press the audio SELECT button to choose S/PDIF
• Release the audio SELECT button to choose analog audio
4. On the TP-45RC, use the SELECT buttons as follows:
• Momentarily press the VIDEO SELECT button. The UXGA
LED turns off when the component video input is selected
• Momentarily press the AUDIO SELECT button to toggle
between the S/PDIF
4
and analog audio inputs
5. On the TP-46, connect the following:
• The Y, C
B/PB, CR/PR RCA connectors to a component video
acceptor (for example, a plasma display)
• The S/PDIF RCA connector
5
to the digital audio acceptor (for
example, the audio input on the plasma display)
6. Connect the LINE OUTPUT RJ-45 connector on the TP-45/TP-45RC to
the LINE IN RJ-45 connector on the TP-46, via twisted pair cabling, see
section 5.4
.
7. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity on both
6
the TP-45/TP-45RC and the
1 Using up to 300ft (100m) of UTP cabling
2 Alternatively, you can connect an analog audio source
3 By default, both switches are set down (for normal V SYNC and H SYNC polarity)
4 The analog audio LED lights when analog audio is selected
5 Alternatively, you can connect an analog audio acceptor, or you can connect both
6 If you cannot connect the power to both the TP-45 and TP-46, connect it to the TP-46 only. If more than one TP-46 is
connected, connect the power to each TP-46 unit