Filter
Top Products
13
Installation
This section describes how to connect the system to
the speakers, a TV monitor with audio / video input jacks
and other video components. You cannot connect this
system to a TV monitor which does not have a video
input connector. Be sure to turn off the power of each
component before making the connectors.
Unpacking
Check that you have the following items:
Main unit (1).
Subwoofer (1).
Speakers (5).
Remote control (1).
Video cable (4 feet x 1).
AM loop antenna (1).
FM antenna (1).
Batteries (2).
Inserting Batteries into the Remote
Control
You can control the system using the supplied remote.
Insert two “AA” batteries by matching the + and - on the
batteries with the markings in the battery compartment.
When using the remote, point it at the remote sensor on
the front panel of this system.
Notes:
Do not leave the remote in an extremely hot or humid
place.
Do not use a new battery with an old one.
Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so many cause a
malfunction.
If you do not use the remote for an extended period
of time, remove the batteries to avoid possible damage
from battery leakage and corrosion.
Use only the size and type of batteries specified.
Be sure to follow the correct polarity when installing
the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
Do not mix different types of batteries together
(e.g. Alkaline and Carbon-zinc) or old batteries with
fresh ones.