Filter
Top Products
61
n Selecting a Transmit Speed
Some repeaters may not respond correctly if a code is transmitted at fast
speed. If this happens, change the EchoLink transmission speed from FAST
(default) to SLOW.
1 Enter Menu mode and access Menu 205 (ELK.SPD) {page 20}.
2 Set the speed to FAST or SLOW.
SETTING UP EchoLink Sysop MODE
When connected to a PC, you can set whether or not to use the RTS and CTS
terminals for hard flow control, or the SQC and PKS terminals for EchoLink. The
action band is the data band (Menu 517(DAT.BND)).
1 Turn the transceiver power OFF.
2 Press [PF2] + Power ON to turn EchoLink Sysop Mode ON.
• The icon appears on the display when EchoLink Sysop mode is ON.
• To turn EchoLink Sysop Mode OFF, press [PF2] + Power ON again.
EchoLink Sysop Mode ON EchoLink Sysop Mode OFF
TM-V71 PC TM-V71 PC
TxD –> RxD TxD –> RxD
RxD <– TxD RxD <– TxD
SQC –> CTS RTS –> CTS
PKS <– RTS CTS <– RTS
GND <–> GND GND <–> GND
Note:
u When in EchoLink Sysop mode, you cannot change to Repeater mode or Remote Control
mode. Additionally, you cannot use the MCP-2A (memory control program) software.
u We recommend you set Menu 520’s SQC output setting to SQL when using EchoLink Sysop
mode.