Filter
Top Products
36
SwITCHINg THE MEMORY NAME/ FREquENCY DISPLAY
After storing memory names, you can switch the display between the memory
name and the stored frequency. This can be useful if you need to confirm the
frequency stored in named Memory channels.
1 Press [MR] to enter Memory Recall mode.
2 Press the Tuning control to toggle between the memory name and the stored
frequency.
<—>
MEMORY-TO-VFO TRANSFER
Transferring the contents of a Memory channel or the Call channel to the VFO
can be useful if you want to search for other stations or a clear frequency, near
the selected Memory channel or Call channel frequency.
1 Press [MR] or [CALL] to enter Memory Recall mode or select the Call
channel.
2 Rotate the Tuning control to select your desired channel. (This step is not
necessary when selecting the Call channel.)
3 Press [F], [VFO].
• The entire contents of the Memory channel or Call channel are copied to the VFO,
and VFO mode is selected after the transfer is complete.
• When copying a transmit frequency from an odd-split Memory or Call channel, you
must first turn the Reverse function ON before pressing [F], [VFO].
CHANNEL DISPLAY FuNCTION
Use this function when you want to use only Memory channels. When this
function is switched ON, the transceiver displays only a Memory channel number
instead of a frequency.
1 Turn the transceiver power OFF.
2 Press [LOW] + Power ON to turn the channel display ON or OFF.
<—>
Note:
u If no Memory channels have saved data in them, channel display will not function.
u
If a channel has a stored name, the name will appear on the display in place of the channel number.
u When using Channel Display, you cannot reset the transceiver.