Filter
Top Products
28
■ Battery Voltage Level
While transmitting, the transceiver automatically
checks the battery voltage level. When the voltage
level becomes low, the LED indicator flashes red.
When a tone sounds, transmission stops. Recharge
or replace the battery pack at this time.
■ Lamp
Press the key programmed as Lamp to toggle the
display backlight ON or OFF. The backlight
automatically turns OFF approximately 5 seconds
after it is switched ON.
Press any key other than Lamp while the backlight is
ON to reset the 5 second timer. The timer will reset
and the backlight will remain on for 5 seconds.
■ Beginning/ End of Transmission Signal
Your dealer can enable or disable the Beginning/
End of Transmission identification signals. These
signals are used to access and release some
repeaters and telephone systems.
To send a Beginning of Transmission signal, either
press the PTT switch, or press the key two times.
To send an End of Transmission signal, either
release the PTT switch or press the key followed
by the # key.
• Ask your dealer which method has been activated on
your transceiver.