Filter
Top Products
22
■ Transmitting
1 Press and hold the PTT switch.
2 Enter the code of the transceiver you want to call
or enter a Group code on the keypad.
• Be sure to enter the ID or Group code, followed by
the Intermediate code of the transceiver you want
to call. If desired, you can also enter a message
code of up to 5 digits.
• If desired, you can send codes the same way you
make DTMF calls {page 15}. Both manual
methods can be used or you can store codes in
memory, then dial them from a memory location.
• “CALL” appears on the display and the LED
indicator lights red.
3 Use the transceiver the same as in a regular call;
press the PTT switch to transmit and release it to
receive.
• When you release the PTT switch, squelch turns
OFF and the LED indicator flashes orange. When
you receive a signal, the LED indicator lights green.
When the signal drops out, the LED indicator
flashes orange again. If no signal is received for a
pre-determined time, squelch turns back ON.
• Pressing the key programmed as Monitor or
Squelch at any time will turn the squelch back ON.